在本地网关设备1上添加如下配置 crypto ikev2 enable outside1#为本地网关设备1的outside1接口（公网接口）开启IKEv2功能。创建IKEv2 Policy，指定IKE阶段认证算法、加密算法、DH分组和SA生存周期，需和阿里云侧保持一致。在本地网关设备1...
具体操作，请参见 搭建IPv4专有网络。您已经创建了云企业网实例，并在华东1（杭州）和华东2（上海）地域分别创建了企业版转发路由器。具体操作，请参见 创建云企业网实例 和 创建转发路由器实例。重要 创建转发路由器实例时，需为转发路由...
cbc-256 integrity sha256 prf sha256 quit ikev2 policy to-ali-policy priority 1 proposal to-ali-prop quit#Configure IKEv2 keychains.Specify the active and standby tunnels on Alibaba Cloud as the two peers.Set the address ...
crypto ikev2 enable outside1 crypto ikev2 enable outside2 创建IKEv2 Policy，指定IKE阶段认证算法、加密算法、DH分组和SA生存周期，需和阿里云侧保持一致。重要 阿里云侧配置IPsec连接时，IKE配置 阶段的 加密算法、认证算法 和 DH分组...
The gateway device of the data center supports the Internet Key Exchange version 1(IKEv1)or IKEv2 protocol.IPsec-VPN supports the IKEv1 and IKEv2 protocols.All gateway devices that support the IKEv1 or IKEv2 protocol can ...
192.168.0.0/16 vSwitch1:192.168.99.0/24,in Zone E vSwitch2:192.168.100.0/24,in Zone F ECS1 IP address:192.168.99.48 VPC2 US(Silicon Valley)VPC:10.0.0.0/16 vSwitch1:10.0.10.0/24,in Zone F vSwitch 2:10.0.20.0/24,in Zone B....
多网段配置建议 IPsec连接及其对端网关设备建议使用IKEv2版本。说明 如果对端网关设备不支持IKEv2版本，则IPsec连接及其对端网关设备可以使用IKEv1版本。在IPsec连接使用IKEv1版本的场景下，一个IPsec连接仅支持配置一个本地端网段和一个对...
本地数据中心的网关设备必须支持IKEv1和IKEv2协议。IPsec-VPN支持IKEv1和IKEv2协议。只要支持这两种协议的设备都可以和阿里云VPN网关互连，例如华三、华为、山石、深信服、Cisco ASA、Juniper、SonicWall、Nokia、IBM和Ixia等。本地数据...
crypto ikev2 policy Pureport_Pol_ikev2 proposal alicloud exit!执行以下命令，配置ikev2 keyring。crypto ikev2 keyring alicloud peer alicloud address 10.0.0.167/配置云上VPN网关的私网IP地址，本示例为10.0.0.167。pre-shared-key ...
IKEv2 simplifies the negotiation process and provides better support for scenarios in which multiple subnets are used.We recommend that you select IKEv2.LocalId The identifier of the IPsec server.The default value is the ...
down list in the IKE Configurations section.Note If the VPN connection protocol is set to ikev1,you can enter only one CIDR block in the Local Network field.Therefore,you must set the VPN connection protocol to ikev2.Add ...
tunnel mode,see Associate an IPsec-VPN connection with a VPN gateway.The gateway device in the data center must support the IKEv1 or IKEv2 protocol to establish an IPsec-VPN connection with a transit router.The CIDR block ...
crypto ikev2 enable outside1 crypto ikev2 enable outside2 创建IKEv2 Policy，指定IKE阶段认证算法、加密算法、DH分组和SA生存周期，需和阿里云侧保持一致。重要 阿里云侧配置IPsec连接时，IKE配置 阶段的 加密算法、认证算法 和 DH分组...
IKEv2 simplifies the SA negotiation process and provides better support for scenarios with multiple CIDR blocks.ikev2 LocalId string The tunnel identifier.The identifier supports FQDNs and IP addresses.The default value is...
IKEv2 simplifies the SA negotiation process and provides better support for scenarios with multiple CIDR blocks.ikev2 LocalId string The tunnel identifier.The identifier supports FQDNs and IP addresses.The default value is...
see Create a VPC with an IPv4 CIDR block.The customer gateway device supports the IKEv1 and IKEv2 protocols for establishing private IPsec-VPN connections.To check whether the gateway device supports the IKEv1 and IKEv2 ...
tunnel mode,see Associate an IPsec-VPN connection with a VPN gateway.The gateway device in the data center must support the IKEv1 or IKEv2 protocol to establish an IPsec-VPN connection with a transit router.The CIDR block ...
VPN connection uses.Use IKEv2 In the left-side navigation pane,choose Interconnections VPN IPsec Connections.On the IPsec Connections page,click Bind VPN Gateway.On the Create IPsec-VPN Connection page,set the parameters ...
{"RemoteId":"116.62.XX.XX","IkeLifetime":86400,"IkeEncAlg":"aes","LocalId":"139.196.XX.XX","IkeMode":"main","IkeVersion":"ikev2","IkePfs":"group2","Psk":"pgw6dy7d1i8i*","IkeAuthAlg":"sha1"},"IpsecConfig":{"IpsecAuthAlg":...
see Create a VPC with an IPv4 CIDR block.The customer gateway device supports the IKEv1 and IKEv2 protocols for establishing private IPsec-VPN connections.To check whether the gateway device supports the IKEv1 and IKEv2 ...
see Create a VPC with an IPv4 CIDR block.The customer gateway device supports the IKEv1 and IKEv2 protocols for establishing private IPsec-VPN connections.To check whether the gateway device supports the IKEv1 and IKEv2 ...
version-(Optional,Computed)the version of the Internet Key Exchange(IKE)protocol.Valid values:ikev1 and ikev2.Default value:ikev1.Compared with IKEv1,IKEv2 simplifies the security association(SA)negotiation process and ...
IKE Configurations Version Select an IKE version.ikev1 ikev2(default)Compared with IKEv1,IKEv2 simplifies SA negotiations and provides better support for scenarios in which multiple CIDR blocks are used.We recommend that ...
ikev1 ikev2（默认值）相对于IKEv1版本，IKEv2版本简化了SA的协商过程并且对于多网段的场景提供了更好的支持，推荐选择IKEv2版本。协商模式 选择协商模式。main（默认值）：主模式，协商过程安全性高。aggressive：野蛮模式，协商快速且...
本地数据中心的网关设备必须支持IKEv1或IKEv2协议，支持任意一种协议的设备均可以和VPN网关实例建立IPsec-VPN连接。本地数据中心和VPC间互通的网段没有重叠。您已了解VPC中所应用的安全组规则，并确保安全组规则允许本地数据中心的网关设备...
如果IPsec连接的IKE版本为 ikev2，且您已排查上述问题无误，请排查IPsec连接及其对端网关设备在 IKE配置 阶段和 IPsec配置 阶段配置的 加密算法、认证算法、DH分组 是否相同，如果不相同，请操作修改以确保两端配置相同。DPD载荷顺序兼容 ...
Hellman key exchange algorithm that is used in Phase 1 negotiations.Default value:group2.ike_version-(Optional)The IKE version.Valid values:ikev1 and ikev2.Default value:ikev2.local_id-(Optional)The identifier of the IPsec...
ip="169.254.30.1"} tunnel_ike_config { ike_mode="aggressive"ike_version="ikev2"local_id="localid_tunnel2"psk="12345678"remote_id="remote2"ike_auth_alg="md5"ike_enc_alg="aes256"ike_lifetime="3600"ike_pfs="group14"} } tunnel...
bgp_config { local_asn="1219002"tunnel_cidr="169.254.30.0/30"local_bgp_ip="169.254.30.1"} tunnel_ike_config { ike_mode="aggressive"ike_version="ikev2"local_id="localid_tunnel2"psk="12345678"remote_id="remote2"ike_auth_alg=...